Minelab EXPLORER II Manuale di Servizio Scaricare il pdf (Pagina 21)

THE MINELAB EXPLORER II

ASSEMBLY

CONNECTING THE SHAFT ASSEMBLY

Figure 2.9 Adjusting the shaft and angle of

the search coil

Figure 2.8 Inserting shaft assembly into

control box

Coil not connected?

These instructions require the

search coil to be connected to the

lower shaft. For directions on this

procedure, refer to page 13.

STEP 5 Secure upper shaft in position by locking the control box

camlock.

STEP 6 (Figure 2.9) Adjust shaft to the desired length and then

lock with shaft camlock lever.

STEP 7 (Figure 2.9) Tilt the search coil to the most comfortable

angle, keeping in mind it will need to be parallel to the

ground during detecting.

NOTE To avoid difficulty securing the control box camlock

lever, ensure the shaft camlock is released to allow greater

shaft movement.

You are now ready to proceed to the handle assembly.

P0599-A

P0598-A

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 111 112

Nessun commento

Minelab EXPLORER II Manuale di Servizio Pagina 21